3/6
2nd try – SUCCEEDED!
- Still couldn’t find 100 ohm resistor, so I tested with breadboard first and decided to use 68 ohm resistor.
- Extended 1/64 short wire
- Replaced some 1/64 with 1/32 to speed up milling
3/5
1st try – FAILED!
- When wiring 1/64 route for milling in Eagle, I made them too short underneath resistor and LEDs thus made circuits inseparate
- Wrong wiring to block the resistor to ground O_O
- Couldn’t find 100 resistor and used 220 resistor –> too much!
- So now it rest on my Failure Wall
